I upgraded to 3.10.24-8 on 2013-12-23. I modified /etc/fixdaemons, adding /etc/init.d/sqm restart input the appropriate sqm settings, transcribed from aqm rebooted and the build works very well. For ADSL2+ here, it is the best so far. On 27/12/13 18:55, Dave Taht wrote: > > A race condition appears to have crept in... > > ---------- Forwarded message ---------- > From: "Dave Taht" > > Date: Dec 27, 2013 10:47 AM > Subject: Re: [Cerowrt-devel] CeroWrt 3.10.24-8 badly bloated? > To: "Richard E. Brown" > > Cc: > > Probably didn't start sqm properly > > Restart it by hand via /etc/init.d/sqm restart > > tc -s qdisc show dev ge00 > > Should show htb and fq codel. > > On Dec 27, 2013 10:36 AM, "Rich Brown" > wrote: > > So I screwed up my courage and replaced my 3.10.18-? firmware in > my primary router with 3.10.24-8. That version had worked well as > a secondary, so I figured, What the heck... Let's give it try. > > The result was not pretty. I set my link speeds in the SQM page, > chose the defaults for the Queue Discipline tab, and link layer to > ATM with no additional overhead for my DSL link. > > Ping times to google are normally ~51-54 msec. But when I fired up > speedtest.net , they jumped to 1500-2500 > msec. Is there something I should look at before reverting? Thanks. > > Rich > _______________________________________________ > Cerowrt-devel mailing list > Cerowrt-devel@lists.bufferbloat.net > > https://lists.bufferbloat.net/listinfo/cerowrt-devel > > > > _______________________________________________ > Cerowrt-devel mailing list > Cerowrt-devel@lists.bufferbloat.net > https://lists.bufferbloat.net/listinfo/cerowrt-devel