I had fired them off an email a few days ago, it looked like very exciting stuff, and a good base for further efforts into getting core bits of code finally into hardware. Assuming they reply sanely I plan to support their kickstarter, and I would hope others here would too. I am not as broke as usual and was planning on buying another zedboard, and will just send them that check instead. I had already assembled a similar set of stuff (zedboard, fmc 4 port card, netfpga´s DRR implementation [1], the senic rate limiter [2]) - but lack time or funding to pursue that further. These folk already are using a much better 4 port chip for ethernet and seem to have assembled other key pieces like pcie support, that make for building the "perfect" debloated device all the more possible. And their projected costs are about 1/20th what I would have expected to do the same thing in the US for. I have also realized that as much as I would like to be designing circuits again things like vivado have a steep learning curve. I really, really liked chisel [3] though. So leveraging their efforts for future hardware work strikes me as a very good idea... [1] https://github.com/NetFPGA/netfpga/wiki/DRRNetFPGA [2] http://cseweb.ucsd.edu/~ssradhak/Papers/senic-nsdi14.pdf [3] https://chisel.eecs.berkeley.edu/ On Tue, Feb 17, 2015 at 10:10 AM, JF Tremblay < jean-francois.tremblay@viagenie.ca> wrote: > Just came across this. > Any thoughts about this platform? A bit pricey, and the wi-fi is an > add-on. Based on Zynq 7030 dual-core. > > > https://www.kickstarter.com/projects/onetswitch/onetswitch-open-source-hardware-for-networking > > JF > > > > > _______________________________________________ > Cerowrt-devel mailing list > Cerowrt-devel@lists.bufferbloat.net > https://lists.bufferbloat.net/listinfo/cerowrt-devel > -- Dave Täht thttp://www.bufferbloat.net/projects/bloat/wiki/Upcoming_Talks