On Fri, Oct 23, 2015 at 9:10 AM, Richard Smith <smithbone@gmail.com> wrote:

I have a shiny new Linksys WRT1900ACS to test.

I thought it might be nice to start with some comparisons of factory firmware vs OpenWRT with sqm enabled.

Here are my results with the same router (unless the WRT1900ACS is different from the WRT1900AC):

http://burntchrome.blogspot.com/2015/06/sqmscripts-before-and-after-at-160mbps.html

So I built and installed an openwrt trunk but the results were very non-impressive. Rrul test reported mulit-seconds of latency and it was equally non-impressive with sqm enabled or disabled. So I assumed that sqm in trunk on this device must not work yet. Then I wondered how well sqm in trunk was tested and that perhaps its broken for all devices.

Trunk or the Chaos Calmer release? (I"m running CC RC1)

My test setup:

Laptop<--1000BaseT-->DUT<--1000baseT-->Server

Which ports on the DUT were you using? are those local ports, or is one of those the "internet" port?

-Aaron