On Fri, Oct 23, 2015 at 1:18 PM, Richard Smith <smithbone@gmail.com> wrote:

On 10/23/2015 02:41 PM, Michael Richardson wrote:

Richard Smith <smithbone@gmail.com> wrote:
> My test setup:

> Laptop<--1000BaseT-->DUT<--1000baseT-->Server

So, given that the DUT is the only real constraint in the network, what
do you expect to see from this setup?

Setting ingress/egress to 10Mbit/s I expected to see the speed measurements bounce around those limits with the ping times staying in the low double digits of ms. What I saw however, was the data rates going well past 10Mbit limit and pings up to 2000 ms.

This is what I've seen in prior rrul testing using a the 50/10 cable link at our office and my 25(ish)/6 link at my apartment and a well connected server on the net. That however was using QoS and not SQM.

Its that a reasonable expectation?

It is, and it's what you should have seen, so I think that it wasn't _actually_ running. I don't remember if I had to reboot or not after installing both sqm_scripts and luci_sqm_scripts on my WRT1900AC.

But the request earlier to run "tc" to show the qdiscs will tell you if it's really setup right or not.

-Aaron