Hi,

Just flashed WNDR3800 with 3.3.8-10 and I get a weird problem.
After flashing it works fine, until I change radio0 and 1 wifi settings:
set WPA2, set channel, etc.
After save&apply, on a cilent PC I am able to see the networks on the list
but it's not possible to connect.
I believe the client associates with the AP, but it has an APIPA address.
Happens to normal and guest interfaces too, even if I don't touch guest
interfaces.

I logged in over the wire to see if dhcpd was running and it was, but since
I can't find logs in the usual place I will now fallback to different
firmware.

Could that be a known issue?

Regards,
Maciej

On Wed, Jul 11, 2012 at 6:56 PM, Maciej Soltysiak <maciej@soltysiak.com>wrote:

> Hi Dave,
>
> Thanks for a good, lengthy update. I wish you pleasant time travelling.
>
> One question on ECN though.
>
>
> On Tue, Jul 10, 2012 at 3:43 AM, Dave Taht <dave.taht@gmail.com> wrote:
>
>> - ECN dropping - after several high level conversations with many
>> people smarter than me, I decided that dropping ECN packets at a
>> certain point made sense. So did everyone else. The "certain point"
>> remains puzzling to all, and
>> rather than continue to waste time on it in cero I decided to play
>> with models instead, and frankly, hope that someone else comes up with
>> some sane way to combine ECN and codel sojourn time.
>
> So if we're dropping ECN packets and not of trying to allow them through
> to communicate congestion am I better of enabling ECN on clients on my
> network or not?
>
> Regards,
> Maciej
>