Hi,
 
Just flashed WNDR3800 with 3.3.8-10 and I get a weird problem.
After flashing it works fine, until I change radio0 and 1 wifi settings: set WPA2, set channel, etc.
After save&apply, on a cilent PC I am able to see the networks on the list but it's not possible to connect.
I believe the client associates with the AP, but it has an APIPA address. Happens to normal and guest interfaces too, even if I don't touch guest interfaces.
 
I logged in over the wire to see if dhcpd was running and it was, but since I can't find logs in the usual place I will now fallback to different firmware.
 
Could that be a known issue?
 
Regards,
Maciej

On Wed, Jul 11, 2012 at 6:56 PM, Maciej Soltysiak <maciej@soltysiak.com> wrote:
Hi Dave,
 
Thanks for a good, lengthy update. I wish you pleasant time travelling.
 
One question on ECN though.


On Tue, Jul 10, 2012 at 3:43 AM, Dave Taht <dave.taht@gmail.com> wrote:
- ECN dropping - after several high level conversations with many
people smarter than me, I decided that dropping ECN packets at a
certain point made sense. So did everyone else. The "certain point"
remains puzzling to all, and
rather than continue to waste time on it in cero I decided to play
with models instead, and frankly, hope that someone else comes up with
some sane way to combine ECN and codel sojourn time.
So if we're dropping ECN packets and not of trying to allow them through to communicate congestion am I better of enabling ECN on clients on my network or not?
 
Regards,
Maciej