[Bloat] Router ethernet devices do not connect to Internet after reboot

Richard E. Brown richb.hanover at gmail.com
Mon Dec 2 12:13:06 EST 2013


Hi Ernesto,

> Well I'm using firmware version 3.10.18-1 and I have used the TFTP method to flash it for the first time then I've tried sysupgrade version also to see if it will fix the reboot problem but to no avail and so I just use the TFTP method.
> 
> Whenever I flash my router with a newer version I wait 10 minutes just to be safe and make sure everything is correct.
> 
> Yes I followed the wiki guide on how to do everything correctly and still the problem persists.
> 
> Is there something I have done wrong?

Hmmm… I don’t see that you’ve done anything wrong.  Just to confirm the symptoms: 

- You can use TFTP to 192.1681.1 to flash the router. 
- If you leave the Ethernet cable attached, your laptop/desktop doesn’t receive a DHCP address after the  5-10 minute wait?
- At that same time, you can connect via Wi-Fi to the router?

If this is the case, I’m going to have to look to others on the list for suggestions. I just jumped in with my short list because I had them in mind…

Best regards,

Rich Brown
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.bufferbloat.net/pipermail/bloat/attachments/20131202/8b5166a5/attachment-0003.html>


More information about the Bloat mailing list