[Bloat] [Cerowrt-devel] capturing packets and applying qdiscs
woody77 at gmail.com
Fri Mar 27 13:21:31 EDT 2015
On Fri, Mar 27, 2015 at 8:08 AM, Richard Smith <smithbone at gmail.com> wrote:
> Using horst I've discovered that the major reason our WiFi network sucks
> is because 90% of the packets are sent at the 6mbit rate. Most of the rest
> show up in the 12 and 24mbit zone with a tiny fraction of them using the
> higher MCS rates.
> Trying to couple the radiotap info with the packet decryption to discover
> the sources of those low-bit rate packets is where I've been running into
> difficulty. I can see the what but I haven't had much luck on the why.
> I totally agree with you that tools other than wireshark for analyzing
> this seem to be non-existent.
Using the following filter in Wireshark should get you all that 6Mbps
radiotap.datarate == 6
Then it's pretty easy to dig into what those are (by wifi frame-type, at
least). At my network, that's mostly broadcast traffic (AP beacons and
whatnot), as the corporate wifi has been set to use that rate as the
without capturing the WPA exchange, the contents of the data frames can't
be seen, of course.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Bloat