[Cerowrt-devel] CeroWrt 3.6.11-3

[Chris Lawrence]

The UPnP problem is a simple mistake: the LuCI interface is strict
XML, and the upnp code uses a bare ampersand without XML escapes.  To
fix:

edit /usr/lib/lua/luci/model/cbi/upnp/upnp.lua, line 16, replacing the
'&' character in "Universal Plug & Play" with 'and'

For ipv6 (using 6to4), I followed the instructions here and got things to work:
http://wiki.openwrt.org/doc/uci/network6.  In my case, all I needed to
do was add 2 lines to /etc/config/network6, after adding a 6to4
interface called "ipv6" through LuCI:

config interface 'ipv6'
    option mode '6to4'

Unlike before there doesn't seem to be an option to specify where to
start the subnet numbering (and the old setting in /etc/config/network
is ignored), but it works fine regardless.

Thanks Dave!


Chris

On Wed, Dec 26, 2012 at 4:19 PM, Richard Brown
<richard.e.brown at dartware.com> wrote:
> Update on 3.6.11-3:
>
> - re: Firmware version. The web GUI now says, "CeroWrt Modena 3.6.11-3" - So this is fixed.
>
> - re: the DHCP address after initial firmware install. Patience, grasshopper… The Flashing Instructions in the wiki say to wait at least 5 minutes after the tftp completes. I waited six minutes, and it got a 172.30.42.x address as desired.
>
> - I'm still planning to play with IPv6.
>
> Rich Brown
> Hanover, NH
> _______________________________________________
> Cerowrt-devel mailing list
> Cerowrt-devel at lists.bufferbloat.net
> https://lists.bufferbloat.net/listinfo/cerowrt-devel



-- 
Chris Lawrence <lordsutch at gmail.com>

Website: http://www.cnlawrence.com/