[Make-wifi-fast] more well funded attempts showing market demandfor better wifi

Bob McMahon bob.mcmahon at broadcom.com
Mon Jun 27 16:05:54 EDT 2016

The ~10K is coming from empirical measurements where all aggregation
technologies are disabled, i.e. only one small IP packet per medium
arbitration/access and where there is only one transmitter and one
receiver.  900Mb/sec is typically a peak-average throughput measurement
where max (or near max) aggregation occurs, amortizing the access overhead
across multiple packets.

Yes, devices can be hidden from each other but not from the AP (hence the
use of RTS/CTS per hidden node mitigation.) Isn't it the AP's view of the
"carrier state" that matters (at least in infrastructure mode?)  If that's
the case, what about a different band (and different radio) such that the
strong signal carrying the data could be separated from the the BSSID's
"carrier/energy state" signal?


On Mon, Jun 27, 2016 at 12:40 PM, David Lang <david at lang.hm> wrote:

> On Mon, 27 Jun 2016, Bob McMahon wrote:
> Hi All,
>> This is a very interesting thread - thanks to all for taking the time to
>> respond.   (Personally, I now have better understanding of the
>> difficulties
>> associated with a PHY subsystem that supports a wide 1GHz.)
>> Not to derail the current discussion, but I am curious to ideas on
>> addressing the overhead associated with media access per collision
>> avoidance.  This overhead seems to be limiting transmits to about 10K per
>> second (even when a link has no competition for access.)
> I'm not sure where you're getting 10K/second from. We do need to limit the
> amount of data transmitted in one session to give other stations a chance
> to talk, but if the AP replies immediatly to ack the traffic, and the
> airwaves are idle, you can transmit again pretty quickly.
> people using -ac equipment with a single station are getting 900Mb/sec
> today.
>   Is there a way,
>> maybe using another dedicated radio, to achieve near instantaneous
>> collision detect (where the CD is driven by the receiver state) such that
>> mobile devices can sample RF energy to get theses states and state changes
>> much more quickly?
> This gets back to the same problems (hidden transmitter , and the
> simultanious reception of wildly different signal strengths)
> When you are sending, you will hear yourself as a VERY strong signal,
> trying to hear if someone else is transmitting at the same time is almost
> impossible (100 ft to 1 ft is 4 orders of magnatude, 1 ft to 1 inch is
> another 2 orders of magnatude)
> And it's very possible that the station that you are colliding with isn't
> one you can hear at all.
> Any AP is going to have a better antenna than any phone. (sometimes
> several orders of magnatude better), so even if you were located at the
> same place as the AP, the AP is going to hear signals that you don't.
> Then consider the case where you and the other station are on opposite
> sides of the AP at max range.
> and then add cases where there is a wall between you and the other
> station, but the AP can hear both of you.
> David Lang
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.bufferbloat.net/pipermail/make-wifi-fast/attachments/20160627/1600b56b/attachment.html>

More information about the Make-wifi-fast mailing list