[Make-wifi-fast] [PATCH v11 4/4] mac80211: Use Airtime-based Queue Limits (AQL) on packet dequeue

[Toke Høiland-Jørgensen]

Felix Fietkau <nbd at nbd.name> writes:

> Hi,
>
> I've take a closer look at the AQL implementation, and I found some
> corner cases that need to be addressed soon:
>
> - AQL estimated airtime does not take into account A-MPDU, so it is
> significantly overestimating airtime use for aggregated traffic,
> especially on high rates.
> My proposed solution would be to check for a running aggregation session
> and set estimated tx time to something like:
> expected_airtime(16 * skb->len) / 16.

This seems reasonable. Not sure if it'll do anything for ath10k (does
mac80211 know the aggregation state for that?), but maybe this is not
such a big issue on that hardware?

> - We need an API that allows the driver to change the pending airtime
> values, e.g. subtract estimated tx time for a packet.
> mt76 an ath9k can queue packets inside the driver that are not currently
> in the hardware queues. Typically if the txqs have more data than what
> gets put into the hardware queue, both drivers will pull an extra frame
> and queue it in its private txq struct. This frame will get used on the
> next txq scheduling round for that particular station.
> If you have lots of stations doing traffic (or having driver buffered
> frames in powersave mode), this could use up a sizable chunk of the AQL
> budget.

I'm a bit more skeptical about this. If the driver buffers a bunch of
packets that are not accounted that will hurt that station due to extra
latency when it wakes up. For ath9k, this is the retry_q you're talking
about, right? The number of packets queued on that is fairly limited,
isn't it? What kind of powersave buffering is the driver doing, and why
can't it leave the packets on the TXQ? That would allow them to be
scheduled along with any new ones that might have arrived in the
meantime, which would be a benefit for latency.

I can see how it can be a problem that many stations in powersave can
block transmissions for *other* stations, though. Maybe an alternative
to the driver subtracting airtime could be to have mac80211 do something
like this when a station is put into powersave mode:

local->aql_total_pending_airtime -= sum(sta->airtime[ac].aql_tx_pending)

(where sum is the summation over all ACs)

and the reverse when the station wakes back up? That should keep the
whole device from throttling but still prevent a big queue building up
for that sta when it wakes back up. Would that work, do you think?

-Toke