[Bismark-devel] flashing woes - instructions don't seem to work
Nick Feamster
feamster at cc.gatech.edu
Thu Apr 14 01:58:41 EDT 2011
Guys,
I think the instructions need some work.
First, I tried the "sysupgrade" with the appropriate binary. That appeared to re-flash the router, but not otherwise do much. After that upgrade, the router appeared on 192.168.42.1, but I could no longer ssh into it, and the normal Web interface did not work.
Then, I figured I would try Srikanth's flashing instructions. First, it's not clear what the "reset" button is. I figure that must be the factory reset button, as opposed to some button on the front of the box (I tried everything). I did not get any of the flashing sequences that the instructions describe. At this point, tftp fails, and I see very strange pings:
1:54am:kenmore-square:tmp% ping 192.168.1.1
PING 192.168.1.1 (192.168.1.1): 56 data bytes
40 bytes from 192.168.1.1: icmp_seq=0 ttl=64 time=-331079123350.339 ms
wrong total length 60 instead of 84
wrong data byte #8 should be 0x8 but was 0x69
cp:61 62 63 64 65 66 67 68
69 6a 6b 6c 6d 6e 6f 70 71 72 73 74 75 76 77 61
62 63 64 65 66 67 68 69 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
dp:4d a6 8c 35 0 d 19 93
8 9 a b c d e f 10 11 12 13 14 15 16 17
18 19 1a 1b 1c 1d 1e 1f 20 21 22 23 24 25 26 27
28 29 2a 2b 2c 2d 2e 2f 30 31 32 33 34 35 36 37
40 bytes from 192.168.1.1: icmp_seq=1 ttl=64 time=-331079122350.903 ms
So, at this point, I am stuck.
-Nick
More information about the Bismark-devel
mailing list