[Bloat] when does the CoDel part of fq_codel help in the real world?
Bless, Roland (TM)
roland.bless at kit.edu
Tue Nov 27 05:26:17 EST 2018
Hi Luca,
Am 27.11.18 um 10:24 schrieb Luca Muscariello:
> A congestion controlled protocol such as TCP or others, including QUIC,
> LEDBAT and so on
> need at least the BDP in the transmission queue to get full link
> efficiency, i.e. the queue never empties out.
This is not true. There are congestion control algorithms
(e.g., TCP LoLa [1] or BBRv2) that can fully utilize the bottleneck link
capacity without filling the buffer to its maximum capacity. The BDP
rule of thumb basically stems from the older loss-based congestion
control variants that profit from the standing queue that they built
over time when they detect a loss:
while they back-off and stop sending, the queue keeps the bottleneck
output busy and you'll not see underutilization of the link. Moreover,
once you get good loss de-synchronization, the buffer size requirement
for multiple long-lived flows decreases.
> This gives rule of thumbs to size buffers which is also very practical
> and thanks to flow isolation becomes very accurate.
The positive effect of buffers is merely their role to absorb
short-term bursts (i.e., mismatch in arrival and departure rates)
instead of dropping packets. One does not need a big buffer to
fully utilize a link (with perfect knowledge you can keep the link
saturated even without a single packet waiting in the buffer).
Furthermore, large buffers (e.g., using the BDP rule of thumb)
are not useful/practical anymore at very high speed such as 100 Gbit/s:
memory is also quite costly at such high speeds...
Regards,
Roland
[1] M. Hock, F. Neumeister, M. Zitterbart, R. Bless.
TCP LoLa: Congestion Control for Low Latencies and High Throughput.
Local Computer Networks (LCN), 2017 IEEE 42nd Conference on, pp.
215-218, Singapore, Singapore, October 2017
http://doc.tm.kit.edu/2017-LCN-lola-paper-authors-copy.pdf
> Which is:
>
> 1) find a way to keep the number of backlogged flows at a reasonable value.
> This largely depends on the minimum fair rate an application may need in
> the long term.
> We discussed a little bit of available mechanisms to achieve that in the
> literature.
>
> 2) fix the largest RTT you want to serve at full utilization and size
> the buffer using BDP * N_backlogged.
> Or the other way round: check how much memory you can use
> in the router/line card/device and for a fixed N, compute the largest
> RTT you can serve at full utilization.
>
> 3) there is still some memory to dimension for sparse flows in addition
> to that, but this is not based on BDP.
> It is just enough to compute the total utilization of sparse flows and
> use the same simple model Toke has used
> to compute the (de)prioritization probability.
>
> This procedure would allow to size FQ_codel but also SFQ.
> It would be interesting to compare the two under this buffer sizing.
> It would also be interesting to compare another mechanism that we have
> mentioned during the defense
> which is AFD + a sparse flow queue. Which is, BTW, already available in
> Cisco nexus switches for data centres.
>
> I think that the the codel part would still provide the ECN feature,
> that all the others cannot have.
> However the others, the last one especially can be implemented in
> silicon with reasonable cost.
More information about the Bloat
mailing list