[Bloat] when does the CoDel part of fq_codel help in the real world?

[Luca Muscariello]

I have never said that you need to fill the buffer to the max size to get
full capacity, which is an absurdity.

I said you need at least the BDP so that the queue never empties out.
The link is fully utilized IFF the queue is never emptied.



On Tue 27 Nov 2018 at 11:26, Bless, Roland (TM) <roland.bless at kit.edu>
wrote:

> Hi Luca,
>
> Am 27.11.18 um 10:24 schrieb Luca Muscariello:
> > A congestion controlled protocol such as TCP or others, including QUIC,
> > LEDBAT and so on
> > need at least the BDP in the transmission queue to get full link
> > efficiency, i.e. the queue never empties out.
>
> This is not true. There are congestion control algorithms
> (e.g., TCP LoLa [1] or BBRv2) that can fully utilize the bottleneck link
> capacity without filling the buffer to its maximum capacity. The BDP
> rule of thumb basically stems from the older loss-based congestion
> control variants that profit from the standing queue that they built
> over time when they detect a loss:
> while they back-off and stop sending, the queue keeps the bottleneck
> output busy and you'll not see underutilization of the link. Moreover,
> once you get good loss de-synchronization, the buffer size requirement
> for multiple long-lived flows decreases.
>
> > This gives rule of thumbs to size buffers which is also very practical
> > and thanks to flow isolation becomes very accurate.
>
> The positive effect of buffers is merely their role to absorb
> short-term bursts (i.e., mismatch in arrival and departure rates)
> instead of dropping packets. One does not need a big buffer to
> fully utilize a link (with perfect knowledge you can keep the link
> saturated even without a single packet waiting in the buffer).
> Furthermore, large buffers (e.g., using the BDP rule of thumb)
> are not useful/practical anymore at very high speed such as 100 Gbit/s:
> memory is also quite costly at such high speeds...
>
> Regards,
>  Roland
>
> [1] M. Hock, F. Neumeister, M. Zitterbart, R. Bless.
> TCP LoLa: Congestion Control for Low Latencies and High Throughput.
> Local Computer Networks (LCN), 2017 IEEE 42nd Conference on, pp.
> 215-218, Singapore, Singapore, October 2017
> http://doc.tm.kit.edu/2017-LCN-lola-paper-authors-copy.pdf
>
> > Which is:
> >
> > 1) find a way to keep the number of backlogged flows at a reasonable
> value.
> > This largely depends on the minimum fair rate an application may need in
> > the long term.
> > We discussed a little bit of available mechanisms to achieve that in the
> > literature.
> >
> > 2) fix the largest RTT you want to serve at full utilization and size
> > the buffer using BDP * N_backlogged.
> > Or the other way round: check how much memory you can use
> > in the router/line card/device and for a fixed N, compute the largest
> > RTT you can serve at full utilization.
> >
> > 3) there is still some memory to dimension for sparse flows in addition
> > to that, but this is not based on BDP.
> > It is just enough to compute the total utilization of sparse flows and
> > use the same simple model Toke has used
> > to compute the (de)prioritization probability.
> >
> > This procedure would allow to size FQ_codel but also SFQ.
> > It would be interesting to compare the two under this buffer sizing.
> > It would also be interesting to compare another mechanism that we have
> > mentioned during the defense
> > which is AFD + a sparse flow queue. Which is, BTW, already available in
> > Cisco nexus switches for data centres.
> >
> > I think that the the codel part would still provide the ECN feature,
> > that all the others cannot have.
> > However the others, the last one especially can be implemented in
> > silicon with reasonable cost.
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.bufferbloat.net/pipermail/bloat/attachments/20181127/05e550e2/attachment-0002.html>