[Bloat] weird problem WRT1200 + CAKE on OpenWrt 18.06.2

[Rosen Penev]

On Fri, Aug 9, 2019 at 10:49 AM Sebastian Moeller <moeller0 at gmx.de> wrote:
>
>
>
> > On Aug 9, 2019, at 19:44, Rosen Penev <rosenp at gmail.com> wrote:
> >
> > On Thu, Aug 8, 2019 at 9:21 PM Mikael Abrahamsson <swmike at swm.pp.se> wrote:
> >>
> >> On Thu, 8 Aug 2019, Toke Høiland-Jørgensen wrote:
> >>
> >>> This looks like you're running sqm-scripts on a VLAN interface? Does it
> >>> make any difference if you run it on the physical eth1?
> >>
> >> Due to how the WRT1200AC is set up internally, this is the only way to do
> >> it. It's how "wan" is set up.
> > Note that OpenWrt uses its NIH swconfig to configure the switch
>
>         Who knew it was the national institute of health that invented swconfig ;)
>
> Best Regards & only kidding
>         Sebastian
>
>
> > instead of DSA. DSA might give you different results.
>
>         I believe Toke's omnia might run DSA already, at least the turris OS 4 betas use DSA instead of swconfig, not that this has any bearing on the wrt1200ac...
Correct. On the Omnia, the WAN port is not connected to the switch.
It's not too relevant here.
>
> >>
> >> --
> >> Mikael Abrahamsson    email: swmike at swm.pp.se_______________________________________________
> >> Bloat mailing list
> >> Bloat at lists.bufferbloat.net
> >> https://lists.bufferbloat.net/listinfo/bloat
> > _______________________________________________
> > Bloat mailing list
> > Bloat at lists.bufferbloat.net
> > https://lists.bufferbloat.net/listinfo/bloat
>