[Cerowrt-devel] 3.10.36-4 field report: dnsmasq made to work

[Michael Richardson]

I have a number of VLANs on port 2, "se00" bridge.

When the cerowrt boots, I wind up with an IPv6 address configured on
both "se00" and "se00.1".  I'm not really sure where the ::1 is coming from.
Having f:2::1 on two interfaces is a fail, and I have to remove it
from se00 manually before IPv6 on that interface works.

Ideas on who/what is doing this?

root at bud:~# ifconfig se00.1
se00.1    Link encap:Ethernet  HWaddr 76:44:01:76:5D:CC
          inet addr:209.87.252.241  Bcast:209.87.252.255  Mask:255.255.255.224
          inet6 addr: 2607:f0b0:f:2::241/64 Scope:Global
          inet6 addr: fe80::7444:1ff:fe76:5dcc/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:42881 errors:0 dropped:0 overruns:0 frame:0
          TX packets:55320 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:5517402 (5.2 MiB)  TX bytes:54942461 (52.3 MiB)

root at bud:~# ifconfig se00
se00      Link encap:Ethernet  HWaddr 76:44:01:76:5D:CC
          inet addr:172.30.42.1  Bcast:172.30.42.31  Mask:255.255.255.224
          inet6 addr: 2607:f0b0:f:2::1/64 Scope:Global
          inet6 addr: 2607:f0b0:f:55::1/64 Scope:Global
          inet6 addr: fe80::7444:1ff:fe76:5dcc/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:54215 errors:0 dropped:29 overruns:4 frame:0
          TX packets:72945 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:10117183 (9.6 MiB)  TX bytes:58659288 (55.9 MiB)
          Interrupt:4

--
]               Never tell me the odds!                 | ipv6 mesh networks [
]   Michael Richardson, Sandelman Software Works        | network architect  [
]     mcr at sandelman.ca  http://www.sandelman.ca/        |   ruby on rails    [