[Cerowrt-devel] openwrt build with latest cake and other qdiscs

Rich Brown richb.hanover at gmail.com
Tue May 5 08:40:07 EDT 2015



I am adapting my CeroWrtScripts to OpenWrt. It still uses standard OpenWrt firewall/bridging/etc.

See config-openwrt.sh in https://github.com/richb-hanover/OpenWrtScripts. So far, it has sections for:
- setting the WAN credentials, 
- updating the opkg repository and loading special packages, 
- setting the root password, 
- setting time zone, 
- enabling SNMP and mDNS on the LAN, 
- and, of course, configuring SQM to a desired state.


On May 5, 2015, at 4:50 AM, Dave Taht <dave.taht at gmail.com> wrote:

> get it from: http://snapon.lab.bufferbloat.net/~cero3/cake/ar71xx/
> Not tested on the 3800 yet, only tested on the archer c7v2. I am about
> to make my gf's main link run this to see what happens...
> * General notes
> ** This is NOT cerowrt. Device naming is std openrt, firewall std
> openwrt, bridged wifi/ethnet, etc. This is basically an attempt at
> testing cake, dnssec, etc.
> ** Unlike the openwrt chaos calmer nightlies this has the gui pre-installed
>    (note that it has both the ssl and non ssl version for no reason I
> can figure out)
> ** babel is installed but not enabled on any interface
> ** numerous other limitations
> * archer notes
> ** You need to opkg update; opkg install kmod-ath10k # and reboot
>    (then configure the wifi interfaces as desired)
> ** sqm defaults to the wrong wan interface for this device
> ** ath10k does not seem to have working adhoc support (thus no babel over
>   5ghz)
> -- 
> Dave Täht
> Open Networking needs **Open Source Hardware**
> https://plus.google.com/u/0/+EricRaymond/posts/JqxCe2pFr67
> _______________________________________________
> Cerowrt-devel mailing list
> Cerowrt-devel at lists.bufferbloat.net
> https://lists.bufferbloat.net/listinfo/cerowrt-devel

More information about the Cerowrt-devel mailing list