[Cerowrt-devel] Problems testing sqm

[Sebastian Moeller]

Hi Aaron,

On Oct 23, 2015, at 19:22 , Aaron Wood <woody77 at gmail.com> wrote:

> 
> 
> On Fri, Oct 23, 2015 at 9:10 AM, Richard Smith <smithbone at gmail.com> wrote:
> I have a shiny new Linksys WRT1900ACS to test.
> 
> I thought it might be nice to start with some comparisons of factory firmware vs OpenWRT with sqm enabled.
> 
> Here are my results with the same router (unless the WRT1900ACS is different from the WRT1900AC):

	I believe the ACS is the success or the AC, basically using the same SoC @higher frequency as the 1200AC, which tested very well in Mikael’s tests recently.

> http://burntchrome.blogspot.com/2015/06/sqmscripts-before-and-after-at-160mbps.html

	But that looks quite nice…

Best Regards
	Sebastian

> 
>  
> So I built and installed an openwrt trunk but the results were very non-impressive.  Rrul test reported mulit-seconds of latency and it was equally non-impressive with sqm enabled or disabled.  So I assumed that sqm in trunk on this device must not work yet.  Then I wondered how well sqm in trunk was tested and that perhaps its broken for all devices.
> 
> Trunk or the Chaos Calmer release?  (I"m running CC RC1)
>  
> My test setup:
> 
> Laptop<--1000BaseT-->DUT<--1000baseT-->Server
> 
> Which ports on the DUT were you using?  are those local ports, or is one of those the "internet" port?
>  
> -Aaron
> _______________________________________________
> Cerowrt-devel mailing list
> Cerowrt-devel at lists.bufferbloat.net
> https://lists.bufferbloat.net/listinfo/cerowrt-devel